Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for BCP SKY2886
Summary of Contents for BCP SKY2886
- Page 1 INSTRUCTION MANUAL Ride-On Police Car SKY2886 + 3995 Ver. 4...
-
Page 2: Battery Warnings
SAFETY Please retain these instructions for future reference. This vehicle must be assembled by an adult who has read and understood the instructions in this manual. Keep the packaging and bags away from children and dispose of all packaging before use. Always use common sense and safe practices when operating this vehicle. -
Page 3: User Warnings
USER WARNINGS The following safety hazards may result in serious injury or death: • Never leave a child unattended. • Always sit in the seat when using this vehicle. • Keep your hands, hair, and clothes away from moving parts. •... -
Page 4: Tools Required
TOOLS REQUIRED PHILLIPS SMALL SCREWDRIVER WRENCH WRENCH 77 LBS 2 PERSON APPROXIMATELY (PROVIDED) ASSEMBLY 45 MIN. CAPACITY ASSEMBLY HARDWARE 4x14MM SCREW 4x14MM ROUND WASHER M10 NUT KNOB COVER SCREW SCREW 6 PCS 4 PCS 1 PCS 20 PCS 10 PCS PARTS FRONT BUMPER CENTER FRAME... -
Page 5: Product Assembly
PRODUCT ASSEMBLY Join the connector from the part A front bumper to the connector within the front part of the vehicle, then conceal the wires in the vehicle body. Flip the vehicle over and lay it on a level surface. Attach the front bumper with four part 1 screws under the hood area of the vehicle. - Page 6 PRODUCT ASSEMBLY Attach the two part B center frame pieces with fourteen part 1 screws, seven on each center frame piece. Slide on a part 3 washer, part C front wheel, and another part 3 washer onto a front wheel axle. Use the wrench to secure it with a part 4 nut.
- Page 7 PRODUCT ASSEMBLY Insert a part F gear box into one side of the rear axle. Route the wires from the gear box through the body of the vehicle and into the seat. Slide on a part D rear wheel and part 3 washer onto the rear axle. Use the wrench to secure it with a part 4 nut.
- Page 8 PRODUCT ASSEMBLY Join the connector from the part H windshield to the connector on the right side of the vehicle, then snap the windshield into place. Attach a part I window frame to the side of the vehicle with five part 2 screws. Repeat on the other side.
- Page 9 PRODUCT ASSEMBLY Within the seat, join the connectors from the gear boxes to the corresponding connectors leading from the front of the car. Insert the Snap on the part K back frame. Note: You may connector from the battery into the designated have to bend the plastic in order to fit the back terminal on the circuit board.
- Page 10 CHARGING INSTRUCTIONS & WARNINGS: • Charging socket is located under the seat. Insert one end of the part M charger into the charging socket and plug the other end into a wall outlet (see Dashboard Diagram). • Charge the battery at least 18 hours before initial use. •...
-
Page 11: Remote Control Diagram
MP3 OPERATION: • AUX input: plug in a music player to play music : short press to play to the next song, long press to increase volume • : short press to play the previous song, long press to decrease volume •... -
Page 12: Product Warranty Information
TROUBLESHOOTING Problem Reason Solution Battery is warm and Normal Normal makes a slight noise while charging Low battery Fully charge the battery Slow speed Overloaded vehicle Reduce the weight on the vehicle Uneven or sloped road Drive on flat pavement Vehicles shakes while Ensure the motor is properly connected to Loose connection to motor...
Need help?
Do you have a question about the SKY2886 and is the answer not in the manual?
Questions and answers