Vertex Standard EVX-534 Operating Manual page 26

rEsEt
Press (or press and hold) the assigned PF key to reset
the RFC (Ready for Communication) condition.
c 1 c 5
all to all
Press, (or press and hold), the assigned PF key to
send a pre-defined 2-tone Sequential Tone Group (on
an analog channel) or a pre-defined Digital Contact
List (on a digital channel).
c u /d
odE p oWn
Press, (or press and hold), the assigned PF key to
select a 2-Tone or 5-Tone encode code from the pre-
programmed encode list.
c s
odE Et
You can change the desired digit of the 5-Tone en-
code code using this function:
 Press, (or press and hold), the assigned PF key.
 Select the desired digit using the [ A ] / [ B ] keys,
then change the number using the SIDE-1/SIDE-
2 buttons.
 Press the [ D ] key to store the new setting. The
display indicates "- SET -" briefly, then reverts to
the normal channel indication.
24
a o
dvancEd pEratIon
You may cancel the new setting by pressing
the [ C ] key. In this case, the display indicates
"- CANCEL -" briefly.
s
pEEd
Your Vertex Standard dealer may have pre-pro-
grammed Auto-Dial telephone number memories into
your radio.
To dial a number, press, (or press and hold), the as-
signed PF key, then press the [ A ] / [ B ] keys to select
the Auto-Dial memory number list provided by your
Vertex Standard dealer or Network Administrator,
then press the PTT switch. The DTMF tones sent dur-
ing the dialing sequence will be heard in the speaker.
c
all
Press, (or press and hold), the assigned PF key to
send a 2-tone or 5-tone sequential tone.
d
Ial
EVX-534 O
pErating
FCC ID: AXI11153020
IC: 10239A-11153020
M
anual