Fixture Temperature - Equinox Systems Shard User Manual

DMX signal lost:
To change what the unit does when the DMX signal is lost, press the "MENU" button and use the "UP"
and "DOWN" buttons on the rear of the unit to show
button and use the "UP" and "DOWN" buttons to choose between
the last DMX command) or
out of any of the above options, press the "MENU" button.
LED backlight:
To access the LED backlight setting, press the "MENU" button and use the "UP" and "DOWN" buttons on
the rear of the unit to show
and "DOWN" buttons to choose between
To exit out of any of the above options, press the "MENU" button.
Display invert setting:
To access the display invert setting, press the "MENU" button and use the "UP" and "DOWN" buttons on
the rear of the unit to show
and "DOWN" buttons to choose between
setting. To exit out of any of the above options, press the "MENU" button.
Fixture test:
To access the fixture test setting, press the "MENU" button and use the "UP" and "DOWN" buttons on
the rear of the unit to show
now run through its tests (colours, full on and then motor rotation).
To exit out of any of the above options, press the "MENU" button.

Fixture temperature:

To access the fixtures temperature, press the "MENU" button and use the "UP" and "DOWN" buttons on
the rear of the unit to show
now display the fixtures temperature.
To exit out of any of the above options, press the "MENU" button.
Fixture hours:
To access the fixtures usage time, press the "MENU" button and use the "UP" and "DOWN" buttons on
the rear of the unit to show
now display the fixtures usage time (hours).
To exit out of any of the above options, press the "MENU" button.
Software version:
To access the fixtures software version, press the "MENU" button and use the "UP" and "DOWN" buttons
on the rear of the unit to show
now display the fixtures software version.
To exit out of any of the above options, press the "MENU" button.
www.prolight.co.uk
bLnd
(Blackout). Press the "ENTER" button to confirm the setting. To exit
Led
on the LED display. Now press the "ENTER" button and use the "UP"
on ofF
or
dIsp
on the LED display. Now press the "ENTER" button and use the "UP"
dISP
or
test
on the LED display. Now press the "ENTER" button. The unit will
teNp
on the LED display. Now press the "ENTER" button. The unit will
Fh-S
on the LED display. Now press the "ENTER" button. The unit will
uer
on the LED display. Now press the "ENTER" button. The unit will
Operating instructions
dNSt
on the LED display. Now press the "ENTER"
NASt
(Master/Slave),
. Press the "ENTER" button to confirm the setting.
dSIP
. Press the "ENTER" button to confirm the
Shard User Manual
LAst
(Hold
8