Equinox Gobo Sweeper Safety WARNING FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOUR INITIAL START-UP! CAUTION! Keep this equipment away from rain, moisture and liquids. SAFETY INSTRUCTIONS Every person involved with the installation, operation & maintenance of this...
Equinox Gobo Sweeper Safety IMPORTANT: The manufacturer will not accept liability for any resulting damages caused by the non-observance of this manual or any unauthorised modification to the equipment. • Never let the power-cable come into contact with other cables. Handle the power-cable and all mains voltage connections with particular caution! •...
Page 4
Equinox Gobo Sweeper Technical specifications You should find inside the carton the following items: 1, Equinox Gobo Sweeper 2, Power cable 3, User manual Technical Specifications: DMX channels: 1, 3, 8, 24 or 28 selectable Operating modes: 1, Sound Activated...
Page 5
Equinox Gobo Sweeper Operation modes Operation modes: DMX mode: To select DMX mode, press the “MENU” button to show “ADDR” on the display and press the “ENTER” button. Now use the “UP” and “DOWN” buttons to set the DMX address from 001-512.
Page 6
Equinox Gobo Sweeper DMX Charts Hour mode (non re-settable) In this mode you can check the total time the unit has been used for. To check the units time line, press the “MENU” button to show “HOUR” on the display. Now press the “ENTER” button to dis- play the units time usage.
Page 9
DATA Cable (DMX cable) requirements (for DMX operation): • The Equinox Gobo Sweeper can be controlled via DMX-512 protocol. The DMX address is set on the back of the unit. Your unit and your DMX controller require a standard 3-pin XLR connector for data input/output (figure 1).
Page 10
Equinox Gobo Sweeper DMX Set Up Notice: • Be sure to follow figures 2 & 3 when making your own cables. Do not connect the cable’s shield conductor to the ground lug or allow the shield conductor to come in contact with the XLR’s outer casing.