Fujitsu B24-9 TE Operating Manual page 26

Operation
Function
V-position
Auto adjust
Sharpness
Saturation
Hue
Expansion
22
Description
Adjusting the picture vertical position
With this function you move the picture up or down.
This setting only appears with an analogue video signal (e.g. VGA).
Perform auto-adjustment of the monitor
With this function, the monitor automatically sets the analogue parameters.
► Press the button to run the function.
The Auto Processing message appears.
This setting only appears with an analogue video signal (e.g. VGA).
Setting the picture sharpness
This function is used to configure the integrated soft focus or sharpness
filter of the monitor.
• Values below 50 produce a softer picture.
• Values above 50 produce a sharper picture.
Setting colour saturation
You can use this function to reduce or increase the intensity of the colours.
This setting only applies for devices with YUV output (e.g. BluRay players).
Setting the colour tone
This function can be used to shift the colour spectrum in order to compensate
for a colour fault that may be present.
This setting only applies for devices with YUV output (e.g. BluRay players).
Adjusting size
This function is used to change the type of scaling of low resolutions.
Full screen = maximum picture size with distortion (no black bands)
Keep aspect = Maximum picture size without distortion (black bands could
appear in one direction)
1:1 = Centred image without scaling (black bands could appear in both
directions). This function is not available on all models.
Fujitsu