Storage; Maintenance - Gardena 9807 Operating Instructions Manual

Filament feed
(Tip mechanism):

5. Storage

To put into storage:
Disposal:
(in accordance with
RL 2012/19/EU)

6. Maintenance

DANGER!
Cleaning the trimmer:
s
The tip mechanism works when the motor is running.
A clean cut is only achieved with the maximum filament length.
During first operation, it may be necessary to extend the cutting
filament several times.
7
1. Start the trimmer.
2. Hold the trimmer head
parallel to the ground and
briefly touch the trimmer
7
head onto a solid surface
(avoid constant pressure over
extended periods of time).
The cutting filament
p
audible switching process and adjusted to the correct length
with the filament limiter
one after the other.
Store out of the reach of children.
v S tore your Turbotrimmer in a dry place where it is protected
from frost.
Recommendation:
The trimmer can be suspended by the handle.
The trimmer head is not placed upon any unnecessary strain
if stored in a suspended manner.
The product must not be added to normal household waste.
It must be disposed of in line with local environmental regulations.
v Important : Make sure that the unit is disposed of via your
municipal recycling collection centre.
There is a risk of injury from the cutting filament!
v Always unplug the mains plug of the Turbotrimmer before
carrying out maintenance work!
Risk of injury and risk of damage to property!
v Never clean the trimmer with water or with a water jet
(in particular a high­pressure water jet).
The ventilation slots must always be free of dirt.
v Clean all moving parts after each use, and especially remove
s
any grass and dirt from the cover
0
7
p
is automatically lengthened with an
a
. If necessary tap several times
0
and ventilation slots
a
p
s
.
17