Rear Panel; Front Panel - Marq Gesture Beam 400 User Manual

Features

Rear Panel

1. Power In: Use a standard power cable
(included) to connect this input to a
power outlet.
2. Fuse: This compartment holds the fuse.
Before cleaning or replacing the fuse,
disconnect Gesture Beam 400 from
its power source. Use a screwdriver or
other tool to remove the compartment
(do not pull it out by the tab only).
Replace the fuse only with a new fuse
with the same rating (250 V, 4 A).
3. Power Out: Use a standard power cable to connect this output to an additional fixture. This
connection will supply power to the additional fixture when this one is connected a power outlet.
Please see Setup > Linking > Power
Note: On models sold in the USA, this will be a standard "Edison" (NEMA
models, this will be a standard IEC connection.
4. Power Switch: Use this switch to power Gesture Beam 400 on/off.
5. DMX In: Use a standard 3-pin DMX cable to connect this input (A) to your DMX controller or (B)
to another fixture that will pass DMX data through it to this one. Gesture Beam 400 receives DMX
data over this connection. Please see
multiple fixtures.
6. DMX Out: Use a standard 3-pin DMX cable to connect this output to an additional fixture.
Gesture Beam 400 sends its data to an additional fixture over this connection. Please see
> Linking > DMX

Front Panel

7. Display: This display shows messages
and values indicating the
current status.
8. Menu: Press this button to access
Gesture Beam 400's menu.
9. Up: Press this button to select the next-
highest menu option or to increase the
value by 1.
10. Down: Press this button to select the
next-lowest menu option or to decrease
the value by 1.
11. Enter: Press this to confirm your current selection or value.
12. DMX: This light will illuminate when Gesture Beam 400 is receiving DMX data properly through
its DMX In.
13. Error: This light will illuminate when Gesture Beam 400 receives an invalid DMX command.
4
for information about linking multiple fixtures.
fixture's
4
for information about linking multiple fixtures.
Setup > Linking > DMX
12
13
1
3
2 5
®
) connection. On other
for information about linking
7
8 9
10 11
6
Setup