Rear Cover - HP ProOne 490 G3 Maintenance And Service Manual

Rear cover

1. Prepare the computer for disassembly (see
2. Remove the stand assembly (see
3. Remove the screw covers (1) from the bottom of the display assembly.
4. Remove the two slotted Phillips P2 screws (2) that secure the rear cover to the display assembly.
5. Remove the rear cover (3) by detaching the bottom edge of the cover from the display assembly, and
then swinging the bottom edge up and back until the rear cover rests upside down behind
the display assembly.
Reverse this procedure to install the rear cover.
18 Chapter 4 Removal and replacement procedures
Preparation for disassembly on page
Stand assembly on page
16).
17).