Curtis RCD313 Operating Instructions Manual page 7

Unit power supply (mains 120V/60Hz)
Connect the power cable plug to the (120V) wall outlet.
Warning:
Before using the unit. Check that the local mains supply is compatible with the HI-FI System (120V 60Hz).
Do not plug or unplug the power cable when your hands wet.
When planning not to use this unit for long periods of time (i.e, Vacation etc.) disconnect the
plug from the wall outlet.
When disconnecting the power cord from the wall outlet, grasp the plug; do not pull the cord in order to avoid
shock risks caused by the damaged cable.
BATTERY SAFETY PRECAUTIONS:
● Keep batteries away from children and pets.
● Insert the battery observing the proper polarity (+/-). Failure to properly align the battery
polarity can cause personal injury and/or property damage.
● Remove weak or discharged batteries from the product. Remove the battery when the
product will not be used for extended periods of time to prevent damage due to rusted or
corroded batteries
● Never throw batteries into a fire, Do not expose batteries to fire or other heat sources
● Battery Disposal: weak or discharged batteries must be properly disposed of and
recycled in compliance with all applicable laws. For detailed information, contact your
local country solid waste authority.
● Follow the battery manufacturer's safety, usage, and disposal instructions.
BATTERY BACKUP:
Two 1.5V "AA" batteries (not included) may be installed as a backup option to maintain the
time if electrical power fails. In the event of a power outage, the time will not appear on the
clock LCD Display, however the clock will continue to operate and the actual time will be
maintained. The Clock LCD Display and other functions will resume once electrical power
is restored if using the backup battery .The backup battery should be replaced as needed;
Remove the battery if the clock is not used or stored for long periods of time.
TO SET THE CLOCK TIME
Connect the AC power cord to a wall outlet. Make sure that it is in "Power off"
mode.(Power off LED indicator inside the power ON/OFF button will illuminate)
1. While pressing and holding the TIME.SET BUTTON, press the HOUR BUTTON to set
desired hour
2. While Pressing and holding the TIME.SET BUTTON, press the MINUTE BUTTON to
set desired minute
TO SET ALARM FUNCTION
1. Power off the unit and enter into "POWER OFF" mode. (Power off LED indicator
inside the power ON/OFF button will illuminate)
2. While pressing and holding the AL.SET BUTTON, press the HOUR BUTTON to
set desired alarm hour.
3. While pressing and holding the AL.SET BUTTON, press the MIN BUTTON to set
desired alarm minute.