Table of Contents
Advertisement
1
Install the shelf supports in the opposite
sequence.
The retaining pins on the
telescopic runners must
point to the front.
10.3 Pyrolysis
CAUTION!
Remove all accessories and
removable shelf supports.
Do not start the Pyrolysis if
you did not fully close the
oven door. In some models,
the display shows "C3" when
this error occurs.
WARNING!
The appliance becomes very
hot. There is a risk of burns.
CAUTION!
If there are other appliances
installed in the same
cabinet, do not use them
when the Pyrolysis function
operates. It can cause
damage to the appliance.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Set the Pyrolysis function. Refer to
"Oven functions".
4. When
flashes, press
set the necessary procedure:
2
or
Option
P1
P2
After 2 seconds the procedure starts.
You can use the End function to delay
the start of the cleaning procedure.
During the Pyrolysis the oven lamp is off.
5. To change the default length of the
procedure (P1 or P2), press
, and then press
the length of the cleaning procedure.
6. When the oven is at its set
temperature, the door locks. The
display shows the symbol
bars of the heat indicator until the
door unlocks.
7. When Pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
8. When the appliance is cool again, an
acoustic signal sounds and the door
unlocks.
10.4 Cleaning reminder
To remind you that the Pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the appliance.
The cleaning reminder
goes out:
to
• after the end of the
Pyrolysis function.
• if you press
the same time while PYR
flashes in the display.
ENGLISH
31
Description
If the oven is
not very
dirty. Time of
the proce‐
dure: 1 h 30
min.
If you cannot
easily re‐
move the
dirt. Time of
the proce‐
dure: 2 h 30
min.
to set
or
to set
and the
and
at
Advertisement
Table of Contents
