Advertisement
Equinox Gobo Sweeper
Operation modes
Operation modes:
DMX mode:
To select DMX mode, press the "MENU" button to show "ADDR" on the display and press the
"ENTER" button. Now use the "UP" and "DOWN" buttons to set the DMX address from 001-512.
When you have finished setting the desired DMX address press the "ENTER" button.
For DMX functions, please refer to the DMX function chart overleaf.
DMX channel mode:
To choose one of the DMX channel modes, press the "MENU" button to show "CHND" on the
display. Now press the "ENTER" button and use the "UP" and "DOWN" button to choose the
1, 3, 8, 24 or 28 DMX channel modes. To confirm your choice, press the "ENTER" button.
Master/slave Mode
To select the slave mode, press the "MENU" button to show "SLND" on the LED display.
Now press the "ENTER" button and use the "UP" and "DOWN" buttons to select either
"MAST" or "SLA1".
"MAST" option: This is the master setting mode, where you can set the first unit as a master.
"SL-1" option: This is the normal slave mode, where the slave units all do the same thing
following the master unit.
Sound active mode:
To select sound active mode, press the "MENU" button to show "SOUN" on the LED display.
Now press the "ENTER" button and use the "UP" and "DOWN" buttons to set the sound active
mode "ON" or "OFF". The unit will now react to the beat of the music.
Note: When there is no music present the unit will automatically switch to slow auto run.
To change the sound sensitivity level, press the "MENU" button to show "SENS" on the LED
display. Now press the "ENTER" button and use the "UP" and "DOWN" buttons to set the sound
sensitivity level from 0-100 (0=low, 100= high).
LED mode
Use this mode to turn the LED display ON or OFF. To do this, press the "MENU" button to show
"BLND" on the display. Now use the the "UP" and "DOWN" buttons to select either "ON" or
"OFF".
Display mode
In this mode you can flip the display over to match which way the unit is being used. To flip the
display, press the "MENU" button to show "DISP" on the display. Now press the "ENTER" button
to flip the display over and again to flip it back to its original position.
Test mode
In this mode you can test that all of the LEDs are illuminating. To do this, press the "MENU" button
to show "TEST" on the display. Now press the "ENTER" button to initiate the test. Once you are
happy with the test, press the "ENTER" button to stop it.
Note: In any of the above mode always press the "ENTER" button to confirm the setting.
Advertisement
