Table of Contents
Advertisement
Using your radio
1.
Plug the AC Power cord into a power outlet and insert DC socket to DC
jack of the unit.
2.
Press the POWER button on the main unit or remote control to turn the
system "On".
3.
If necessary, press the FUNCTION button to select the Radio mode and
the frequency will be shown in display.
4.
To switch between FM and AM bands press the STOP/BAND button on
the front panel or remote.
5.
Automatic Tuning - Depress and hold the SKIN/TUNE UP or DN buttons
until the display begins to move, then release the buttons. The tuner will
scan up or down the band until it finds the first strong station, and then
stop on that station. Repeat this process until the tuner stops on your
desired station.
6.
If you tune to an FM Stereo station the "(ST)" indicator appears in the
display.
7.
Manual Tuning - Press the SKIP/TUNE UP or DN buttons repeatedly
until the display is showing the frequency of your desired station. Use the
manual tuning method to tune to weaker stations that are bypassed during
Automatic Tuning.
T
1.
With the power off.
2.
Press and hold the MEM/CLK
3.
Press the SKIP/TUNE UP or DN Buttons to set the unit to the 24 hour
4.
Press the MEM/CLK
5.
Press the SKIP/TUNE UP or DN Buttons to set the current hour, then press
the MEM/CLK again; the minute digits will blink. Press the SKIP/TUNE UP
6.
Press the MEM/CLK Button to confirm the time.
OPERATING INSTRUCTIONS
10
Advertisement
Table of Contents
