Makita DGA405 Instruction Manual page 9

Press the shaft lock to prevent spindle rotation when
installing or removing accessories.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing side grip (handle)
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
015309
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing wheel guard
(For depressed center wheel, multi disc /
abrasive cut-off wheel, diamond wheel)
WARNING:
When using a
•
wheel/Multi-disc, flex wheel, wire wheel brush, cut-
off wheel or diamond wheel, the wheel guard must
be fitted on the tool so that the closed side of the
guard always points toward the operator.
When using an abrasive cut-off / diamond wheel,
•
be sure to use only the special wheel guard
designed for use with cut-off wheels.
For tool with clamp lever type wheel guard
1
2
015084
Loosen the lever on the wheel guard after loosening the
screw. Mount the wheel guard with the protrusion on the
wheel guard band aligned with the notch on the bearing
box. Then rotate the wheel guard to such an angle that
depressed center grinding
1. Wheel guard
2. Bearing box
3. Screw
4. Lever
3
4
it can protect the operator according to work.
2
1
015085
Tighten the lever to fasten the wheel guard. If the lever is too
tight or too loose to fasten the wheel guard, loosen or tighten
the screw to adjust the tightening of the wheel guard band.
To remove wheel
procedure in reverse.
For tool with locking screw type wheel guard
1
2
015303
Mount the wheel guard with the protrusion on the wheel guard
band aligned with the notch on the bearing box. Then rotate the
wheel guard to such an angle that it can protect the operator
according to work. Be sure to tighten the screw securely.
To remove wheel
procedure in reverse.
Installing or removing depressed center
wheel or multi disc (optional accessory)
WARNING:
When using a depressed center wheel or multi disc, the
•
wheel guard must be fitted on the tool so that the closed
side of the guard always points toward the operator.
Only actuate the shaft lock when the spindle is not moving.
•
015310
Mount the inner flange onto the spindle.
Make sure to fit the dented part of the inner flange onto
the straight part at the bottom of the spindle.
9
1. Screw
2. Lever
3. Wheel guard
3
guard, follow the installation
1. Wheel guard
2. Bearing box
3. Screw
3
guard, follow the installation
1. Lock nut
1
2. Depressed
2
center wheel
3. Inner flange
3