Genie GTH-1256 Operator's Manual page 34

October 2015
Operating Instructions
Parking Brake
Use the parking brake switch to apply the parking
brake before raising the boom or leaving the
machine.
Push the top of the rocker switch to turn the
parking brake on.
Push the bottom of the switch to turn the parking
brake off.
Brake Pedal
Use the brake pedal to control the machine speed
and to stop the machine motion.
Push and hold the brake pedal to stop the
machine.
Push and release the brake pedal to control the
machine speed.
Starting the Engine
6 Be sure the parking brake is set and the
transmission control lever is in the neutral
position.
7 Insert the key in the ignition switch.
Turn the key until the engine starts.
If the engine fails to start after 30 seconds of
cranking, determine the cause and repair any
malfunction. Wait 120 seconds before trying to
start again.
32
Starting in Cold Condition
In cold conditions, 20°F / -6°C and below, warm
the engine for 5 minutes before operating to
prevent hydraulic system damage.
In extreme cold conditions, 0°F / -18°C and below,
machines should be equipped with optional cold
start kits. Attempting to start the engine when
temperatures are below 0°F / -18°C may require
the use of a booster battery.
Raising and Lowering the
Stabilizers
Push the top of the rocker switch to extend/lower
the stabilizers. Push the bottom of the rocker
switch to raise/retract the outrigger.
Steer Select
Always position all wheels in line with the machine
before switching the steering mode.
Do not realign the wheels while driving.
GTH-1256
Second Edition - First Printing
Part No. 57.0009.0662