Lexmark S400 Series Service Manual page 25

Error
Name
Code
1201 Print Incomplete
1202 Data Error
1203 Printhead Short
1204 Printhead Programming
1205 Mono TSR Error
1206 Color TSR Error
Description
The print carrier stopped before
all of the data was used.
Incorrect data has been sent
from the host computer to the
All-In-One.
The short test detected a short
circuit in the printhead.
Firmware is unable to program
pseudo-random printhead ID.
There is a problem in the color
TSR circuit; cannot determine
printhead temperature.
There is a problem in the color
TSR circuit; cannot determine
printhead temperature.
Lexmark S400 Series
Action
Technical Support Center:
Clear any carrier jams. Unplug the All-In-
One from the wall outlet, wait a few
seconds, then plus the All-In-One back in
and turn the power on. Resend the print
job.
Service:
Clear any carrier jams. Unplug the All-In-
One from the wall outlet, wait a few
seconds, then plus the All-In-One back in
and turn the power on. Resend the print
job.
Technical Support Center:
Unplug the All-In-One from the wall outlet;
wait a few seconds, then plug the All-In-
One back in and turn the power on. If the
problem remains, then replace the USB
cable.
Service:
Replace the system board. See
board removal" on page
Technical Support Center:
Remove the printhead. Clean and reinstall
the printhead. If this does not correct the
problem, then replace the printhead.
Service:
Remove the printhead. Clean and reinstall
the printhead. If this does not correct the
problem, then replace the printhead.
Technical Support Center:
Replace the printhead.
Service:
Replace the printhead.
Technical Support Center:
Replace the printhead.
Service:
Replace the printhead.
Technical Support Center:
Replace the printhead.
Service:
Replace the printhead.
Diagnostic information
"System
4-28.
2-5