FLEXIDOME IP starlight 6000 VR
3.
1
5.5.3
Twist
To obtain a horizontal horizon (for tilted ceilings or sidewall mounting), twist the camera
module to align the picture shown on the monitor.
5.6
Local set-up
The Menu button on the control panel is used to access the camera install wizard. When there
is a choice in the wizard, the options are selected by either a short press (less than 2 s) or a
long press (more than 2 s) of the Menu button.
Use the install wizard for the following functions:
–
–
–
–
Note:
The zoom and focus are adjusted again later (with the dome bubble in place) via the web
browser. This optimizes picture sharpness in both bright and low-level lighting.
5.6.1
Using the install wizard
To perform the set-up:
1.
2.
3.
4.
5.
6.
7.
Bosch Security Systems B.V.
Tighten the two thumbwheels (1).
1
Choose application variant
Change image orientation
Activate automatic back focus
Choose analog output
Power-up the camera and wait briefly until all LEDs show green.
Open the camera install wizard by pressing the Menu button.
To change the variant, briefly press Menu a number of times until the desired variant is
shown (remember that changing the variant will reboot the system and may eventually
need a reset to return to factory defaults).
To confirm the selected variant, press Menu for a longer time.
To rotate the image 180°, press and hold Menu until the image flips.
Briefly press the Menu button to set the start position for the automatic motorized focus
adjustment.
–
You will hear the motorized automatic back focus process running.
–
The progress is shown on the monitor.
Briefly press the Menu button again and again to scroll through the preset zoom
positions.
–
The selection loops back to the beginning when you reach the last one.
≤90°
Installation manual
Installation | en
15
03.2019 | V2.0 | AM18-Q0711