Table of Contents
Advertisement
FLEXIDOME IP starlight 6000 VR
If using a recessed 4s mounting box, attach the camera to the box using two screws and
washers (M4 x 14).
5.4.2
Mounting to ceiling with SMB-IP
To mount the camera using a Surface Mount Box and cable conduit:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Close the cover on the conduit and position the conduit inside the SMB.
11. Feed the other camera cabling through the cable hole in the SMB.
12. If IP66 water ingress protection is required, connect the camera cabling to the source
13. Mount the camera to the SMB using the 3 supplied screws (M5x16mm torx).
Bosch Security Systems B.V.
Use the SMB to mark out the cable hole in the ceiling and to mark the three mounting
holes. The mounting holes are equally spaced around a diameter of 133 mm (5.25 in).
Cut out the cable hole in the ceiling, and use a 8 mm (0.31 in) bit to drill the three
mounting holes.
Insert the supplied mounting plugs (8 x 40) into the mounting holes.
Use the supplied screws (pozidrive DIN7505-B 50mm) to securely attach the SMB to the
surface.
Feed the Ethernet RJ45 cable from source through the ceiling into the SMB
Remove the cover from the SMB cable conduit and slide out the rubber seals at either
end.
Thread the Ethernet cables from the camera and source through the seals (they can be
pulled open to fit the cables). If required, use the larger bore seal (supplied in parts
package) to fit thicker cables.
Slot the seals (with cables) into either end of the conduit.
Connect the Ethernet cables inside the conduit using the supplied RJ45 shielded
connector.
cabling inside an IP66 approved box.
Earth
+12 VDC
Power
IP66
Alarm
Audio
CVBS
STP Cat5e
RJ45
Ethernet
(PoE)
Installation manual
Installation | en
13
03.2019 | V2.0 | AM18-Q0711
Advertisement
Table of Contents
