Operating The Radio - Pyle PPTCM80BTGR User Manual

--- SPEAKER CONNECTION FOR EXTERNAL SPEAKERS - RCA JACK
Before using main unit, You should connect the external speakers (4 ohm) via the "Speaker output" L, R
sockets (cables and external speakers are included), as shown below (line drawing for reference, not actual
product):
1. Connect the red cables of external speaker to external speaker terminal (+) on main unit
2. Connect the black cables of external speaker to external speaker terminal (-) on main unit
Note: Sound will directly come from the external speakers.
AM/FM TUNER
1. Set the FUNCTION button (12) to the TUNE position.
2. Select the desired frequency with the BAND selector.
3. Tune in to the desired radio station by turning the Tuning control knob (18). You can also use the
BACK/NEXT buttons (15/17) to automatically search for the previous or next available radio station.
4. Adjust the volume +/- to the desired level.
5. Press the POWER (11) button to turn off the radio.
FM stereo and mono reception
When an FM signal is tuned in, press the MODE button on the remote to select FM ST; this will enable
stereo reception for the broadcast. The FM stereo indicator „ON‟ will appear on the LCD display.
Hints for best reception:
- AM: The receiver has a built-in AM antenna. If AM reception is weak, slightly turning or changing the
position of the unit will usually improve the AM reception.
- FM: The receiver has a built-in FM antenna (29) hanging at the rear cabinet. This wire should be fully
unravelled and extended for best reception.

OPERATING THE RADIO

-
3