Troubleshooting; Opening The Door In An Emergency - Panasonic NA-140XR1 Operating & Installation Instructions Manual

Opening the Door in an Emergency

When the door stays locked due to a
power failure, or while displaying an
error that starts with "H", the door can
be opened using the following
instructions.
1 Turn off the power, and open the
drain filter cover. (P.31)
2 When there is water in the drum,
drain the water by removing the
drain filter. (P.31)
3 Pull down the emergency door
unlock tab.
The door lock is released, and you
can open the door.
Emergency door
unlock tab
32
CAUTION
●
There is a risk of burns during
operation at high temperatures.
- Operate after temperature has
fallen.
●
There is a risk of injury if you put
your hand in the drum during
rotation.
- Operate after the rotation has
stopped.
●
Opening the door when water
can be seen through the glass of
the door may cause the water to
spill.
- Drain the water by removing the
drain filter. (P.31)

Troubleshooting

Problem
- Settings cannot be changed while an operation is in
progress. Only the spin speed, "Extra Rinse" and "Easy
Buttons do not
Iron" settings can be changed when the wash process is
work
paused.
- The Child Lock (
- The door is locked while an operation is in progress.
(P.14)
- The Child Lock (
- The temperature inside the drum may be very high.
- The water level may be too high.
■To open the door immediately
Door does not open
(1) Switch the appliance off and then on again. (P.10)
(2) Select the "Cotton" programme.
(3) Select O in "Mode" (P.26), and start operation.
- If you switch off the appliance or there is a power cut
while the door is locked, it remains locked until the power
is turned on again.
- Rubber parts may give off a smell when you first use the
Unusual odour
appliance, but the smell will go away over time.
- Run a wash at 60 °C to clean the drum. (P.30)
- The tap may be turned off.
No water going into
- The water supply may be disrupted.
the appliance
- The water supply hose may be frozen. (P.29)
- The water supply filter may be blocked. (P.29)
Water builds up
- This is normal. Water is automatically supplied if the
during a wash
water level falls.
- If there is excess foam, water is drained out and fresh
water supplied to remove the foam. This is the foam
Water drains out
detection function.
during a wash
- Even if water is directly supplied to the drum, it may
drain away without building up.
- The water supply is automatically stopped if the water
Water supply stops
volume in the drum reaches a certain level, and some
and water is
water may drain away. This feature is called the overflow
drained away
detection function.
Cause and Measures
) may be activated. (P.28)
B A
) may be activated. (P.28)
B A
33