2. Push the throttle lever forward until it stops
and hold it in this position.
1
3. Check through each carburetor window to see
if the punch mark on the throttle valve is at the
2
specified position.
3
1
4
5
2
6
7
8
1. Punch mark
9
2. Specified position: 0–1mm
10
4. If not, loosen the locknut and turn the adjust-
ing nut until the specified position is obtained.
11
1
1. Adjusting nut
2. Locknut
5. Move the throttle lever a few times and re-
check the position.
6. Install the fuel tank, side cover, radiator cover
and air filter case cover.
7. Connect the fuel hoses.
8. Install the seat.
EBU24020
Adjusting the engine idling speed
The engine idling speed must be checked and, if
necessary, adjusted as follows at the intervals
specified in the periodic maintenance and lubrica-
8-28
2