Yamaha BANSHEE YFZ350W Owner's Manual page 103

Assembling and installing the carburetors
Assemble and install both carburetors by the fol-
lowing steps.
1. Install the needle valve and float.
2. Install the float chamber by installing the
screws.
3. Install the carburetor and tighten the joint
screws.
4. Assemble the throttle valve.
5. Install the mixing chamber cap, and then tight-
en it securely to the specified torque.
Tightening torque:
Mixing chamber cap:
4 Nm (0.4 m·kgf, 2.9 ft·lbf)
6. Install the mixing chamber cap securing plate
by installing the screw.
ECB00501
CAUTION:
Be sure to match one of the projections on the
carburetor cap with one of the slots on the se-
curing plate. If the securing plate does not
match a projection, tighten the carburetor cap
until they align. Do not loosen the carburetor
cap.
1. Mixing chamber cap securing plate
2. Projection
3. Slot
4. Screw
7. Tighten the mixing chamber cap securing
plate screw to the specified torque.
Tightening torque:
Mixing chamber cap securing plate screw:
3.5 Nm (0.35 m·kgf, 2.5 ft·lbf)
8. Tighten the carburetor joint screws.
Adjusting the throttle cables
1. Move the throttle lever a few times.
8-27
2
1
4
1
2
3 3
4
5
6
7
8
9
10
11