Initial Setup - Vivitar DVR 548NHD User Manual

Initial Setup

Flip open the LCD screen. When powering the camera ON for the first time the camera will take you
through the initial camera setup.
Powering the Camera ON
1) Installing the Batteries
Remove the battery compartment cover.
Insert the batteries properly into your digital camcorder, according to the polarity shown inside
the battery compartment.
Close the battery compartment cover securely.
Use 4 x AAA (1.5V) batteries. Alkaline batteries are recommended. (Batteries not included.)
Note:

Remove the batteries from the camera when not in use for an extended period.

Do not mix alkaline and non-alkaline batteries.

Some camera features (Flash) will not work if the battery power level is low.

When the battery power is low, the battery icon appears empty and 'Battery Low' appears on
the LCD screen. The camcorder automatically turns off a few seconds later.

The energy status of the power is displayed on LCD as shown below:
Full battery power Medium battery power
7
Low battery power