Yamaha GRIZZLY 125 YFM125GB Owner's Manual page 82

1
4
1. Engine oil drain bolt
2. O-ring
3. Spring
4. Oil strainer
8
5. Clean the oil strainer with solvent.
6. Apply a thin coat of clean engine oil to a new
O-ring.
7. Install the oil strainer, the compression spring,
the new O-ring and the engine oil drain bolt.
Tighten the engine oil drain bolt to the speci-
fied torque. NOTICE: Before installing the
engine oil drain bolt, be sure to install the
O-ring, compression spring and oil strain-
er.
[ECB00321]
1
3
2
Tightening torque:
Engine oil drain bolt:
32 Nm (3.2 m·kgf, 23 ft·lbf)
8. Refill with the specified amount of the recom-
mended engine oil, and then install and tight-
en the engine oil filler cap.
Recommended oil:
See page 10-1.
Oil quantity:
1.25 L (1.32 US qt, 1.10 Imp.qt)
TIP
Be sure to wipe off spilled oil on any parts after the
engine and exhaust system have cooled down.
ECB00330
NOTICE
G Do not use oils with a diesel specification of
"CD" or oils of a higher quality than speci-
fied. In addition, do not use oils labeled "EN-
ERGY CONSERVING II" or higher.
G
Make sure that no foreign material enters the
crankcase.
8-13