Axle Boots; Brake Light Switches; Checking And Lubricating The Cables - Yamaha GRIZZLY 350 YFM350DF Owner's Manual

EBU24231

Axle boots

The axle boots must be checked for damage at
the intervals specified in the periodic maintenance
and lubrication chart. Check the axle boots for
tears or damage. If any damage is found, have
them replaced by a Yamaha dealer.
1
1. Axle boot (each side)
EBU29882

Brake light switches

The brake light, which is activated by the brake
pedal and brake levers, should come on just be-
fore braking takes effect.
The rear brake light switch for the brake pedal can
be adjusted as follows, but the other brake light
switches should be adjusted by a Yamaha dealer.
Turn the rear brake light switch adjusting nut while
holding the brake light switch in place. To make
the brake light come on earlier, turn the adjusting
nut in direction (a). To make the brake light come
on later, turn the adjusting nut in direction (b).
1
1. Rear brake light switch
2. Rear brake light switch adjusting nut
EBU24905

Checking and lubricating the cables

The operation and the condition of all control ca-
bles should be checked before each ride, and the
cables and cable ends should be lubricated if nec-
8-36
8