Operating The Parking Brake - Toro 74259 Operator's Manual

7
11
4
Figure 11
1. Ignition switch
2. Motion control lever
3. Parking brake lever
4. Throttle
5. MIL (Malfunction Indicator
Light)
Using the Hour Meter
The hour meter records the number of hours the engine
has operated. It operates when the engine is running. Use
these times for scheduling regular maintenance.
Figure 12
1. Hour meter
Using the Malfunction Indicator Light
The malfunction indicator light lets the user know there is
a problem with the fuel injection system.
If the malfunction indicator light (MIL) illuminates,
during operation, the electronic control unit (ECU) has
detected a problem or fault in the electronic fuel injection
(EFI) system.
6 8
3 1
2
5
10
9
M–4821
6. Power take off (PTO)
7. Height-of-Cut lever
8. Fuel cap
9. Fuel shut off lever
10. Hour meter
11. Deck lift assist
1
m–3077
Once the MIL illuminates, initial trouble shooting checks
should be made. Refer to Troubleshooting on page 58
under the MIL section.
If these checks do not correct the problem, further
diagnosis and servicing by an Authorized Service Dealer
is necessary.
Switching the Fuel Tanks
The unit has two fuel tanks. One tank is on the left side
and one on the right side. Each tank connects to the fuel
shut off valve in the control panel. From there a common
fuel line leads to the engine (Fig. 13).
To use the right side fuel tank rotate the fuel shut off valve
a 1/4 turn to the left from the off location. This uses fuel
from the right hand tank only. When the right hand fuel
tank is empty, move the fuel shut off valve 1/4 turn to the
left from the right hand tank position. This uses fuel from
the left hand tank.
Close fuel shut off valve, on front panel before
transporting or storing machine.
Figure 13
1. Shut-off valve
Note: If the machine runs out of fuel, the fuel injection
system may need the air bled out of the system. Contact
an Authorized Service Dealer for this procedure.

Operating the Parking Brake

Always set the parking brake when you stop the machine
or leave it unattended.
Setting the Parking Brake
1. Move the motion control levers (Fig. 11) out to the
neutral lock position.
2. Pull back and up on the parking brake lever to set the
parking brake (Fig. 14). The parking brake lever
should stay firmly in the engaged position.
22
1