Checking The Deck Side-To-Side Leveling; Changing The Side-To-Side Leveling; Matching Height Of Cut - Toro ProLine 30334 Operator's Manual

3
4
Figure 50
1. Caster Wheel
2. Carrier Frame
3. Front height–of–cut pins
4. Position the blades front-to-rear (Fig. 48). Measure at
"C" and "D" locations (Fig. 48) from a level surface to
the cutting edge of the blades (Fig. 49).
5. Check the side-to-side leveling of the cutting unit.
Checking the Deck
Side-to-Side Leveling
1. Check the tire pressure on both deck and traction unit.
2. Position the blades side-to-side (Fig. 51). Measure at
"A" and "B" locations (Fig. 51) from a level surface to
the cutting edge of blade tips (Fig. 52).
3. The difference between measurements "A" and "B"
should be no more than 1/4 in. (6 mm).
Figure 51
2
5 1
m–5231
4. Jam nut
5. Ball joint
m–1078
Changing the Side-to-Side
Leveling
Changing the side–to–side leveling is done by adjusting tire
pressure.
Changing the Side–to–Side Leveling with
Tire Pressure
1. Change the tire pressure on both deck and traction unit.
Do this to the corresponding side that needs adjustment.
2. Recheck the front-to-rear pitch and side to side leveling
of the cutting unit.

Matching Height of Cut

1. Check the tire pressure on both deck and traction unit.
2. Set the height-of-cut to the 4 in. (102 mm) position
following the height-of-cut decal.
3. With the machine on level surface, position one blade
front-to-rear (Fig. 53). Measure at "A" and from level
surface to the cutting edge of the blade tips (Fig. 54).
4. The measurement should be 4 in. (102 mm)
35
Figure 52
Figure 53
m–2550
m–1078