Shutting Off The Engine; Recycling The Clippings; Bagging The Clippings - Toro 20332 Operator's Manual

Figure 19
Note: If the machine does not freely roll backward after
self-propelling, stop walking, hold your hands in place, and
allow the machine to roll a couple of centimeters (inches)
forward to disengage the wheel drive. You can also try
reaching just under the upper handle to the metal handle and
push the machine forward a couple of centimeters (inches).
If the machine still does not roll backward easily, contact an
Authorized Service Dealer.

Shutting Off the Engine

Service Interval: Before each use or daily
To shut off the engine, release the blade-control bar.
Important: When you release the blade-control bar,
both the engine and blade should stop within 3 seconds.
If they do not stop properly, stop using your machine
immediately and contact an Authorized Service Dealer.

Recycling the Clippings

Your machine comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
If the grass bag is on the machine and the bag-on-demand
lever is in the Bagging position, move the lever to the
Recycling position before recycling the clippings; refer to
Operating the Bag-on-Demand Lever (page
side-discharge chute is on the machine, remove it before
recycling the clippings; refer to
Chute (page 12).

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
If the side-discharge chute is on the machine, remove it before
bagging the clippings; refer to
Chute (page 12). If the bag-on-demand lever is in the
Recycling position, move it to the Bagging position; refer to
Operating the Bag-on-Demand Lever (page
11). If the
Removing the Side-Discharge
Removing the Side-Discharge
11).
Installing the Grass Bag
1. Raise and hold up the rear deflector
1. Rear deflector
2. Notches (2)
2. Install the grass bag, ensuring that the pins on the bag
rest in the notches on the handle
3. Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps in
Bag (page 11).
Operating the Bag-on-Demand Lever
The bag-on-demand feature allows you to either collect or
recycle grass and leaf clippings while the grass bag is attached
to the machine.
•
For bagging the grass and leaf clippings, press the button
on the bag-on-demand lever and move the lever forward
until the button on the lever pops up
11
(Figure 20).
Figure 20
3. Grass-bag pin (2)
(Figure 20).
Installing the Grass
(Figure 21).