Advertisement
Available languages
Available languages
3) In this mode the effect is controlled by the FADE slider control and not by the stored values. Only if the FADE control is
set to 0 (completely set down), the programmed patterns will be run.
4) Select a running light program via the CHASE keys.
5) Press the TAP-SYNC/DISPLAY key and browse through the memory via the BANK arrow keys.
AUTOMATIC RUN
1) Press the AUTO/DEL key. The AUTO TRIGGER LED on the display must light up.
2) Select a running light program via one of the CHASE keys.
3) Adjust the light effects via the SPEED and FADE controls until you are satisfied.
4) By tapping three times on the TAP SYNC key to the rhythm of the music, the setting of the SPEED control is overrun
and replaced by the rhythm of the music.
5) Switch this mode off by pressing the AUTO/DEL key.
MUSIC CONTROL
1) Press the MUSIC/BANK-COPY key. The MUSIC TRIGGER LED must light up.
2) Select a running light pattern via one of the CHASE keys.
3) The built-in microphone controls now the running of the patterns.
4) Switch this mode off by pressing the MUSIC/BANK-COPY key.
MIDI CONTROL
1) Switch this protocol on by pressing the MIDI/REC key for 3 seconds.
2) Select the required MIDI bank via the BANK arrow keys.
3) Switch this mode off by pressing the MIDI/REC key for 3 seconds.
Specifications
MIDI input
5-pin DIN
Power Supply 220-240Vac/50Hz - 10W
Dimensions
482 x 132 x 70mm
Weight
2.0kg
www.beamzlighting.com
Advertisement
