Advertisement
Available languages
Available languages
1) Activate the programming mode by pressing the PROGRAM key for 2 seconds. The PROG LED is flashing on the
display.
2) Select the running light program via the CHASE keys (1-6) to which you wish to add one or more scenes (steps).
3) Press the TAP SYNC/DISPLAY key once. The STEP LED will light up on the display.
4) Select the step number via the BANK arrow keys behind which you wish to insert a new scene.
5) Program a new scene as described in the section PROGRAMMING OF RUNNING LIGHT SCENES.
6) Press the MIDI/REC (MIDI/ADD) key and the step sequence number on the display increases by 1.
7) Press once again the MIDI/REC (MIDI/ADD) key and the scene will be added.
8) Press the TAP SYNC/DISPLAY key and then the PROGRAM key in order to leave the program mode.
CLEARING A STEP (SCENE)
1) Activate the programming mode by pressing the PROGRAM key until the PROG LED on the display is flashing.
2) Choose the running light program via one of the CHASE keys from which you want to remove a step (scene).
3) Press the TAP SYNC/DISPLAY key once.
4) Use the BANK up/down keys to choose the step number (scene) to be cleared.
5) Press the AUTO/DEL key once. The scene is cleared and the display flashes to confirm.
6) Press the TAP SYNC/DISPLAY and then the PROGRAM key to leave the programming mode.
CLEARING A RUNNING LIGHT PATTERN (CHASE)
1) Keep the desired CHASE key (1-6) pressed and press at the same time the AUTO/DEL key once.
CLEARING ALL RUNNING LIGHT PATTERNS
1) Keep the AUTO/DEL key pressed and switch the power supply off by unplugging the power connector on the rear side.
2) Release the AUTO/DEL key and switch the power supply on again.
PLAYING THE PROGRAMMED SCENES
Manual Operation
1) After having switched on the power supply, always start the DMX operator in the manual mode.
2) Check if the indicator LEDs MUSIC TRIGGER and AUTO TRIGGER on the display are switched off. If necessary,
press the MUSIC/BANK-COPY and AUTO/DEL keys to switch them off.
3) Select the desired memory bank via the BANK arrow keys and press the SCENE keys (2).
Automatic Play
1) This function allows you to play in cycle all scenes that are programmed in a memory bank.
2) Press the AUTO/DEL key to activate the automatic play mode. The AUTO TRIGGER LED on the display must light up.
3) Select the desired memory bank via the BANK arrow keys. The scenes are now played in sequence.
4) The SPEED and FADE controls are used to set the speed and the fading time.
5) During automatic play you can at any time chose another memory bank via the BANK arrow keys.
MUSIC CONTROL
1) Switch the music-control on via the MUSIC/BANK-COPY key. The built-in microphone reacts to the rhythm of the
music.
2) Select the desired memory bank via the BANK arrow keys.
3) Press the MUSIC/BANK-COPY key to switch the music controlled mode off.
USE OF RUNNING LIGHT PATTERNS
MANUAL OPERATION
1) Prior to running light patterns you need to program scenes !
2) This function enables you to play scenes manually in random sequence.
www.beamzlighting.com
Advertisement
