Cleaning; Washing The Underside Of The Mower - Toro 71255 Operator's Manual

Cleaning

Washing the Underside of the
Mower
Service Interval: Before each use or daily
Wash the underside of the mower to prevent grass
buildup for improved clipping dispersal.
1. Park the tractor on a level surface.
2. Disengage the blade control (PTO).
3. Stop the engine, wait for all moving parts to stop, and
remove the key before leaving the operating position.
4. Attach the coupling (not included) to the mower
washout fitting and turn the water on high
(Figure 42).
Figure 42
1. Washout fitting
2. Coupling (not included)
Note: Spread petroleum jelly on the washout fitting
o-ring to make the coupling slide on easier and to
protect the o-ring.
5. Lower the mower to the lowest height of cut.
6. Sit on the seat and start the engine.
7. Engage the blade control (PTO) and let the mower
run for 1 to 3 minutes.
8. Disengage the blade control (PTO).
9. Stop the engine, wait for all moving parts to stop, and
remove the key before leaving the operating position.
10. Remove the ignition key.
11. Turn the water off and remove the coupling from
the washout fitting and hose.
12. Run the mower again for 1 to 3 minutes to remove
the excess water.
3. Hose
WARNING
A broken or missing washout fitting could expose
you and others to thrown objects or to blade contact.
Contact with the blade or thrown debris contact
may cause injury or death.
• Replace broken or missing washout fitting
immediately, before using the mower again.
• Plug any holes in the mower with bolts and
locknuts.
• Never put your hands or feet under the mower
or through openings in the mower.
31