General International AC1106 Setup And Operation Manual page 5

11. CHECK FOR DAMAGE.
Check your tool regularly. If part of the tool is damaged it should be
carefully inspected to make sure that it can perform its' intended
function correctly. If in doubt, the part should be repaired. Refer all
servicing to a qualified technician. Consult your dealer for advice.
12. STORE IDLE TOOLS
out of the reach of children and untrained persons. Tools may be
dangerous in the hands of untrained users.
13. MAINTAIN TOOLS WITH CARE.
Keep tools sharp and clean. Properly maintained tools, with sharp
cutting edges, are less likely to bind and are easier to control.
14. NEVER EXCEED THE PRESSURE RATING OF ANY COMPONENT
IN SYSTEM.
15. PROTECT MATERIAL AND AIR LINES FROM DAMAGE OR
PUNCTURE.
Keep hose and power cable away from sharp objects, moisture,
chemicals, oil, etc.
16. CHECK CONDITION OF HOSES BEFORE EACH USE.
Do not use a damaged hose. If hose is damaged, replace immediately.
17. READ, UNDERSTAND AND COMPLY WITH ALL WARNING
LABELS ON UNIT.
18. DRAIN TANK OF MOISTURE AFTER EACH USE.
If Compressor is not to be used for extended periods of time, leave
tank drain valve open to allow moisture to completely drain from tank.
19. DO NOT TAMPER WITH SAFETY VALVE.
The Safety Valve is factory set for your model air compressor. Any user
adjustments to Safety Valve will automatically void warranty.
20. AIR COMPRESSORS GET HOT WHILE IN OPERATION.
Never touch the motor, discharge tubing or compressor pump while in
operation.
21. THE COMPRESSOR OPERATES AUTOMATICALLY WHILE THE
motor is turned on.
22. COMPRESSED AIR FROM THE UNIT MAY CONTAIN CARBON
MONOXIDE.
Air produced is not suitable for breathing purposes.
23. ALWAYS USE A RESPIRATOR WHEN SPRAYING PAINT OR
CHEMICALS.
24. THE AIR PRESSURE SWITCH IS SET AT THE FACTORY
for optimum performance of your equipment. Never attempt to bypass
or remove this switch as serious damage to equipment or personal
injury could result from excessive air pressure.
Amp Rating Feet
25
3-10 amp 18 ga.
10.1 - 12 amp 16 ga.
12.1 - 16 amp 14 ga.
Total Extension Cord Length
Meters Feet Meters
8 50
16 ga.
16 ga.
12 ga.
Use only UL or CSA approved extension cords
Feet Meters
15 100 30
14 ga.
14 ga.
Not Recommended
Feet Meters
125 40
14 ga.
14 ga.
1410162
141209
5 5