Advertisement
Initial Camera Settings
-
Insert fully charged battery and formatted SD card.
-
Set Date and Time.
-
Set Shooting Mode to "P" Program.
-
Set ISO to 100 and White Balance to auto "AWB."
-
Set the Square to "Single Shot."
-
Set Resolution to "L" and "1280."
-
Set AF Frame to "Center" and Digital Zoom to "Off."
-
Set AF Point Zoom to "Off" and Servo AF to "Off."
A strobe focusing light is recommended to assist AF underwater.
-
Set Lamp Setting to "Off" and Red-Eye Correction to "Off."
-
Set Light Metering to "Center Weighted."
-
Set Review to "5 Seconds" and Review Info to "Off."
-
Set Blink Detection and Grid Lines to "Off."
-
Set Flash to "On
-
In Power Saving, set Auto Power Down to "Off."
-
In Power Saving, set Display Off to "3 min."
Note: Enable Macro
overexposure occurs, back away from the subject and zoom in and/or
use "-" Exposure Compensation.
External Accessory Lenses
Attach 46mm threaded #6420.46 Ikelite W-20 Wide-Angle Lens or other
compatible lenses directly to the front of the port.
Attach 67mm threaded #6420 Ikelite W-20, Inon Type II and Epoque
wide-angle lenses using the #9306.81 port adapter. This adapter may
also be used to attach other compatible 67mm threaded macro lenses.
Attach bayonet style Inon macro or UWL-100 28AD, UWL-105AD and
UFL-165AD wide angle or macro lenses using the #9306.79 port adapter.
Slight vignetting (shading in the corners) may be present in the widest
setting when using an external accessory lens. This effect can be
eliminated by zooming in slightly.
flash always fires."
mode when shooting close-up subjects. If
3
Advertisement
