Completing The Parts Replacement - Lenovo s510 User Manual

6. Install the new PCI Express card into the appropriate PCI Express card slot on the system board.
See "Parts on the system board" on page 6 .
7. Pivot the card latch to the closed position to secure the PCI Express card.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 57.

Completing the parts replacement

After completing the installation or replacement for all parts, reinstall the computer cover and reconnect
cables. Depending on the parts you installed or replaced, you might need to confirm the updated information
in the Setup Utility program. Refer to "Using the Setup Utility program" on page 29.
To reinstall the computer cover and reconnect cables to your computer, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are
left inside your computer. See "Computer components" on page 5 for the locations of various
components in your computer.
2. Ensure that the cables are routed correctly before reinstalling the computer cover. Keep cables clear of
the hinges and sides of the computer chassis to avoid interference with reinstalling the computer cover.
3. Position the computer cover on the chassis so that the rail guides on the bottom of the computer
cover engage the rails on the chassis. Then, push the cover to the front of the computer until it snaps
into position.
Figure 24. Installing the computer cover
4. Install the screws to secure the computer cover.
5. Place the computer in an upright position.
6. If a locking device is available, use it to lock the computer. See "Locking your computer" on page 25.
7. Reconnect the external cables and power cords to the corresponding connectors on the computer.
See "Hardware locations" on page 1 .
8. Update your configuration. See "Using the Setup Utility program" on page 29.
9. If a newly installed hardware component does not work normally, update the device driver. See
"Keeping your computer current" on page 22.
.
Chapter 7 Installing or replacing hardware
57