Replacing The Heat Sink And Fan Assembly - Lenovo s510 User Manual

3. Locate the memory module you want to replace. The memory modules are installed in the memory slots
on the system board. See "Parts on the system board" on page 6 .
4. Open the retaining clips and gently pull the memory module out of the memory slot.
Figure 15. Removing a memory module
5. Position the new memory module over the appropriate memory slot. Ensure that the notch
memory module aligns correctly with the slot key
straight down into the slot until the retaining clips close.
Figure 16. Installing a memory module
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 57.

Replacing the heat sink and fan assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page iii .
CAUTION:
The heat sink and fan assembly might be very hot. Before you open the computer cover, turn off the
computer and wait several minutes until the computer is cool.
52
Lenovo S510 User Guide
2
on the system board. Push the memory module
1 on the