Description Of The Appliance (Pic. 1); Preparation And Use - Hyundai GR 009 Instruction Manual

– In terms of fire safety the grill conforms to the norm EN 60 335-2-6. According to this norm this is
an appliance that may be operated on a table or a similar surface under the condition that in the
direction of the main heat radiation, i.e. above the hotplate, a safe distance of 500 mm must be
maintained from flammable materials and at least 100 mm in the other directions.
– Regularly check the condition of the appliance's power cord.
– Use the appliance only for the purpose it is intended for, pursuant to these instructions for use.
Never use the appliance for any other purpose.
– The manufacturer takes no responsibility for damages caused by the incorrect use of this
appliance and accessories (e.g. ruining of foods, injury, burns, scalding, fire) and takes
no responsibility arising from the warranty on the appliance in the case that the above safety
notices were not followed.

DESCRIPTION OF THE APPLIANCE (pic. 1)

A – gril
A1 – thermostat knob
A2 – operating light indicator
A3 – heating elements
A4 – grill rack (3 positions)
A5 – aluminum tray
A6 – handles
A7 – grill base
A8 – feets
* Do not put food on bottom tray A10 without packaging.

PREPARATION AND USE

Assembling and disassembling the grill (see scheme in pic. 1)
First attach the covers A11 and A13 to the posts A12. Using screws, attach the posts to the base
holder A9 and the lower tray. You will get a stable bearing part of the grill. Then screw on the
feet A8 to the base A7. You may then put thus assembled base on the above-mentioned bearing
part. Put the aluminium tray A5 onto the protrusions in the base A7 in a way that the MIN and
MAX marks are opposite the regulation knob. Now you can attach the whole part with the heating
body and regulation knob into the prepared cut out parts of the base A7 (see pic. 1). The guiding
wire of the grilling grate must fit onto the prepared hollows of the aluminium tray (see pic. 1). Now
put the wind shield A14 in the base A7 and then you may put the grilling grate on it.
Place the appliance on a hard and level surface. Place the aluminium reflector into the base and
dip water carefully in before power on. Water must not come into contact with other parts of
the grill (eg, A1, A2, A3, A15) ! The water shall not be lower than the minimum level marked on
the A5 tray. If water evaporates fast during baking, please add water into for avoiding over heat.
Do not directly spray water onto the thermostat, for it may possibly damage the appliance.
Cautions!
– The barbecue grill shall be covered with aluminium reflector or similar materials, otherwise
it may cause the danger of overheat.
– NEVER use the unit without water in the base tray. The water level must be between the
MIN & MAX marks. When filling in water, turn the grill off frist and unplug the supply cord!
A9 – base holder
A10 – bottom tray
A11 – upper column cover
A12 – column
A13 – lower column cover
A14 – wind rack
A15 – power cord
31 / 43
ENG