Adjusting The Feet; Aquasafe; Electrical Connection; Initial Use - Beko DFS28020X Instruction Manual

Adjusting the feet

If the door of the product cannot
be closed properly or if the product
swings when you push it slightly,
then you need to adjust the feet
of the product. Adjust the feet of
the product as illustrated in the
installation manual supplied with the
product.

Aquasafe+

(depends on the model)
Protect the Aquasafe+ system
against water leaks that may occur
at hose inlet. Water contact with
the valve box of the system must
be prevented. Otherwise, electrical
assembly will get damaged. If the
Aquasafe system is damaged, unplug
the product and call the Authorised
Service Agent.
A
As the hose set contains electrical
connections and assemblies,
never shorten or lengthen the
hose with extension hoses.

Electrical connection

Connect the product to a grounded
outlet protected by a fuse complying
with the values in the "Technical
specifications" table. Manufacturer
shall not be liable for any damages
that will arise when the product
is used without grounding in
accordance with the local regulations.
•
Connection must comply with
national regulations.
•
Power cable plug must be within
easy reach after installation.
A
Unplug the product after the
washing programme is over.
•
The voltage and allowed fuse or
breaker protection are specified
in the "Technical specifications"
section. If the current value of
the fuse or breaker in the house
is less than 16 Amps, have a
qualified electrician install a 16
Amp fuse.
•
The specified voltage must be
equal to your mains voltage.
•
Do not make connections via
extension cables or multi-plugs.
B
Damaged power cables must
be replaced by the Authorised
Service Agent.
B
If the product has a failure, it
should not be operated unless
it is repaired by the Authorised
Service Agent! There is the risk of
electric shock!

Initial use

Before starting to use the product,
make sure that all preparations
are made in accordance with the
instructions in sections "Important
safety instructions" and "Installation".
•
To prepare the product to do the
dishes, perform first operation
in the shortest programme with
detergent while the machine is
empty. During the initial use, fill
the salt reservoir with 1 litre of
water prior to filling it with salt.
C
Some water might have remained
in the product due to the
quality control processes in the
production. It is not harmful for
the product.
9 EN