Technical Information - Zanussi ZRT23100WA User Manual

Hide thumbs Also See for ZRT23100WA:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 10
Problem
The lamp does not come on.
The compressor operates continu-
ously.
Water collects on the rear plate of
the fridge.
Water collects in the fridge.
There is water on the floor.
The temperature in the appliance is
too cold
The temperature in the appliance is
not sufficiently cold.
The temperature in the fridge is not
sufficiently cold.
There is too much frost.

Technical information

Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient tempera-
ture corresponds to the climate class indicated
on the rating plate of the appliance:
16
Do a check and see if there is voltage. Connect a different appliance
to the same mains socket. To repair a mains socket, contact a qualified
electrician.
Close and open the door to make sure that the lamp is not in standby.
The lamp is defective. Replace the lamp.
Set the temperature knob at a lower position.
Make sure that the appliance door is closed.
Make sure not to open and close the appliance door too frequently.
Make sure not to put hot food in the appliance. Wait until it becomes
cool.
Make sure that the room temperature is not too warm.
It is normal that this occurs when the automatic defrosting operates.
Make sure that the drain hole is not clogged.
Make sure that food or packaging do not prevent the water to collect
in the water container.
The melting water outlet does not flow in the evaporative tray above
the compressor.
Attach the melting water outlet to the evaporative tray.
Set the temperature knob to a lower position.
Set the temperature knob to a higher position.
Make sure that the appliance door is closed.
Make sure not to put hot food in the appliance. Wait for the food to
become cool.
Make sure that the appliance is not too full.
Make sure that there is cold air circulation.
Make sure that the food is closed in special containers or packaging.
Make sure that the appliance door is closed.
Set the temperature knob to a lower position.
Possible solution
www.zanussi.com

Advertisement

Table of Contents
loading

Table of Contents