Mp3 Player; Usb Storage Devices; Auto Standby; Set Display Brightness - Philips HTL2183B User Manual

MP3 player

Connect your MP3 player to play your audio
files or music.
What you need
• An MP3 player.
• A 3.5mm stereo audio cable.
1
Using the 3.5mm stereo audio cable,
connect the MP3 player to the AUDIO IN
connector on this product.
2
Press AUDIO IN on the remote control.
3
Press the buttons on the MP3 player to
select and play audio files or music.

USB storage devices

Enjoy audio on a USB storage device, such as an
MP3 player and USB flash memory, etc.
What you need
• A USB storage device that is formatted for
FAT or NTFS file systems, and complies
with the Mass Storage Class.
• An MP3 file on a USB storage device
1
Connect a USB storage device to this
product.
2
Press USB on the remote control.
3
Use the remote control to control play.
• Press to start, pause or resume play.
• Press / to skip to the previous or
next track.
During USB play, press and hold USB to
•
enter repeat mode, then press USB to
select one of the following play modes.
• ONE RPT: repeat the current track.
ALL RPT: repeat all the tracks in one
•
folder.
SHUFFLE: play randomly in one folder.
•
OFF RPT: exit repeat or shuffle play
•
mode.
Note
•
This product may not be compatible with certain types
of USB storage device.
•
If you use a USB extension cable, USB HUB, or USB
multi-reader, the USB storage device may not be
recognized.
•
Digital camera PTP and MTP protocols are not
supported.
•
Do not remove the USB storage device while it is
being read.
•
DRM-protected music files (MP3) are not supported.
•
Support a USB port: 5V

Auto standby

When playing media from a connected device,
this product automatically switches to standby
after 15 minutes of button inactivity and no
audio/video play from a connected device.

Set display brightness

You can press DIM repeatedly to select a
different brightness level of the display panel on
this product.
If you select AUTO OFF, LED message is
switched off after 10 seconds of button
inactivity.

Apply factory settings

You can reset this product to the default
settings programmed at the factory.
1
In any source mode, on the remote control
press Volume -, BASS -, and TREBLE - in
sequence within three seconds.
» When the factory settings restore is
complete, the product automatically
switches off and restarts.
, 1A.
EN 11