Table of Contents
Advertisement
1
Press SURR to turn surround mode on
or off.
•
On: Create a surround listening
experience.
Off: Two-channel stereo sound. Ideal
•
for listening to music.
Sound mode indicator
•
If surround mode is turned on, all the LED
indicators light up one by one, with all the
LED indicators on for three seconds. Finally
the current source indicator stays on.
•
If surround mode is turned off, all the LED
indicators light up, then light off one by
one. Finally the current source indicator
stays on.
Note
•
Virtual surround is applicable for the audio codecs, such
as MP3, PCM and MPEG (except Dolby Digital).
Equalizer
Change the high frequency (treble) and low
frequency (bass) settings of the SoundBar.
1
Press TREBLE +/- or BASS +/- to change
the treble or bass.
Treble/bass indicator
•
The more treble/bass you change to, the
more LED indicators light up. If you do
not press the treble/bass button for three
seconds, the treble/bass indicators light off.
•
All the LED indicators blink three times
when treble or bass is set to the maximum
or minimum value.
Synchronize video and sound
If the audio and video are not synchronized,
delay the audio to match the video.
1
Press AUDIO SYNC +/- to synchronize
the audio with the video.
•
AUDIO SYNC + increases the sound
delay, and AUDIO SYNC - decreases
the sound delay.
8
EN
Sound delay indicator
•
The more delay you change to, the more
LED indicators light up. If you do not press
the sound delay button for three seconds,
the sound delay indicators light off.
Note
•
This feature is only applicable to COAXIAL (COAX)
and OPTICAL (OPT) sources.
Night mode
For quiet listening, night mode decreases the
volume of loud sounds when audio is played.
Night mode is only available for Dolby Digital
soundtracks.
1
Press NIGHT to turn night mode on or
off.
Night mode indicator
•
If night mode is turned on, all the LED
indicators light up one by one, with all the
LED indicators on for three seconds. Finally
the current source indicator stays on.
•
If night mode is turned off, all the LED
indicators light up, then light off one by
one. Finally the current source indicator
stays on.
MP3 player
Connect your MP3 player to play your audio
files or music.
What you need
•
An MP3 player.
•
A 3.5mm stereo audio cable.
1
Using the 3.5mm stereo audio cable,
connect the MP3 player to the AUDIO IN
connector on your SoundBar.
2
Press AUDIO IN on the remote control.
3
Press the buttons on the MP3 player to
select and play audio files or music.
Advertisement
Table of Contents
