Echo pe-225 Operator's Manual page 39

Power edger

Hide thumbs Also See for pe-225:

Table of Contents

PE-225

Do not store in enclosure where fuel fumes may accumulate or

reach an open flame or spark.

Place the stop switch in the "OFF" position.

Remove accumulation of grease, oil, dirt and debris from exterior of

unit.

Perform all periodic lubrication and services that are required.

Tighten all the screws and nuts.

Drain fuel tank completely. Press purge bulb 6-7 times to remove

remaining fuel from carburetor then drain the tank again. Close choke,

start and run the engine until it stops due to lack of fuel.

Allow engine to cool. Remove the spark plug lead from the spark plug.

Remove the spark plug. Pour 7 cc (0.25 oz.) of fresh, clean, two-stroke

engine oil into the cylinder through the spark plug hole.

Pull the recoil starter handle 2-3 times to distribute the oil inside the

engine.

Observe the piston location through the spark plug hole. Pull the recoil

handle slowly until the piston reaches the top of its travel and leave it

there.

10. Install the spark plug. Connect the spark plug lead to the spark plug.

X7732272804

STORAGE

Table of Contents