How To Use - Panasonic CS-RE9SKUA Operating Instructions Manual

How to use

MODE
To select operation mode
AUTO - For your convenience
• During operation mode selection the POWER
indicator blinks.
• Unit selects operation mode every 10 minutes
according to setting temperature and room
temperature.
HEAT - To enjoy warm air
• Unit takes a while to warm up. The POWER
indicator blinks during this operation.
COOL - To enjoy cool air
• Provides effi cient comfort cooling to suit your
needs.
DRY - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
FAN - To circulate air in the room
POWERFUL/
To switch between
QUIET
powerful & quiet
POWERFUL QUIET
POWERFUL: To reach temperature quickly
POWERFUL
• This operation stops automatically after 20
minutes.
QUIET: To enjoy quiet operation
QUIET
• This operation reduces airfl ow noise.
Can be activated in all modes and can be
cancelled by pressing the respective button again.
Auto OFF/ON button
6
ACXF55-00750_SS1015-0.indb 6 ACXF55-00750_SS1015-0.indb 6
NORMAL
Use when remote control is misplaced or a malfunction occurs. Raise the front panel:
1. Press the button once to use in AUTO mode.
2. Press and hold the button until you hear 1 beep, then release to use in forced
COOL mode.
3. Repeat step 2. Press and hold the button until you hear 2 beeps, then release to
use in normal COOL mode.
4. Repeat step 3. Press and hold the button until you hear 3 beeps, then release to
use in forced HEAT mode.
• Press the button again to turn off.
Remote control receiver
and indicator
POWER
TIMER
POWERFUL
QUIET
Remote control display
AUTO FAN
SPEED
HEAT
AIR
COOL
SWING
DRY
FAN
OFF/ON OFF/ON
MODE
TEMP TEMP
AIR SWING
POWERFUL/ /
QUIET FAN SPEED
TIMER TIMER
ON ON SET SET
1 1 3 3
2 2
OFF OFF CANCEL CANCEL
AC RC
SET CHECK CLOCK CHECK RESET
(Green)
(Orange)
(Orange)
(Orange)
Press and hold for
approximately
10 seconds to show
temperature setting in
°F or °C.
Press and hold for
approximately
5 seconds to show
12-hour (am/pm) or
24-hour time indication.
Press to restore the
remote control to
default setting.
Not used in normal
operations.
07/01/2016 9:24:42 AM 07/01/2016 9:24:42 AM