Mitsubishi Electric Mr. Slim PCA Series Service Manual page 38

OPERATING PROCEDURE
10. Removing the thermistors/Liquid pipe (TH2) and con-
denser/evaporator (TH5)
(1) Remove the air intake grille. (See Figure 1, 2)
(2) Remove the left and right side panels. (See Figure 3, 4)
(3) Remove the under panel. (See Photo 13)
(4) Remove the drain pan. (See Photo 14, 15, 16)
(5) Disconnect the connector CN44 (white) from the indoor
controller board.
(6) Remove 6 screws from the pipe cover and remove the
pipe cover. (See Photo 14, 17)
(7) Remove the fastener for wires and remove the thermistors
(TH2 and TH5) from each holder. (See Photo 18)
11. Removing the guide vane
(1) Remove the intake grille. (See Figure 1, 2)
(2) Remove the side panel (right and left). (See Figure 3, 4)
(3) Remove the under panel. (See Photo 13)
(4) Remove the drain pan. (See Photo 14, 15, 16)
(5) Remove the screw from the guide vane, then remove
the guide vane.
12. Removing the Auto vane
(1) Remove the intake grille. (See Figure 1, 2)
(2) Remove the right side panel. (See Figure 3, 4)
(3) Remove the vane motor and cover. (See Photo 12)
(4) Slide the auto vane to the vane motor side.
(5) Remove 2 axes from each vane support pushing the
vane support to the vane sleeve side.
OCH585
PHOTOS
Photo 17
Pipe cover fixing
screws
Pipe cover
Photo 18
Condenser/evaporator
tempertature thermistor
(TH5)
Liquid pipe
temperature
thermistor (TH2)
Photo 19
Screw
Guide vane
Photo 20
Vane sleeve Vane support
38
Pipe cover
fixing screws
(See Photo 15)
Fastener
Drain pan
Vane
Vane motor side