Operation - Lighting Instructions - Coleman Revolution Use & Care Manual

WARNING
Most Coleman barbecue's are sold either Natural Gas or Propane Ready, and are not convertible.
Any attempt to convert a barbecue that does not have a convertible valve system will permanently
damage the barbecue's manifold and will be unusable.
ONLY barbecue's bearing the Convertible Valve System logo on the front of the barbecue's
control panel, are convertible from propane to natural gas. Visit www.cvsbbq.com to see if your
barbecue has this feature.
OPERATION — LIGHTING INSTRUCTIONS
Lighting — Burners:
1. Open the lid.
2. Make sure all burner control knobs are turned "OFF". (Push the
control knob in and turn clockwise, to ensure that the control knob
is in the "OFF" position.)
3. Turn the LP tank valve ON slowly (turn counter clockwise). Wait for
pressure to stabilize for 5 seconds.
4. Light the ignition burner first. Push in and turn control knob counter
clockwise to "MAX" position (
5. Push the INSTASTART™ ignition button. You should hear rapid
clicks. Repeat if necessary.
6. Check that the burner is lit.
7. After the burner is lit you can turn on the other burner control knobs.
If the Revolution™ burner fails to light properly within 3-5 seconds, turn the burner control knob "OFF". Also
turn off the LP cylinder valve. Wait five minutes before attempting to light the burner again. This will allow
time for released gas to disperse.
WARNING
The burner control knobs must be in the "OFF" position before turning on the liquid propane
cylinder tank valve. If left in the "ON" position, when the LP cylinder valve is opened, the
"Flow Limiting Device" feature will activate, limiting the flow of gas from the LP cylinder. If
this should occur, turn "OFF" the LP cylinder valve and burner control knobs and follow the
"Resetting the flow limiting device instructions".
WARNING
Never stand with your head directly over the barbecue when preparing to light the main burners,
to prevent possible bodily injury.
Match-lighting — Burners
Repeat steps 1-3 "Lighting - Burners" above.
4. To match light: push in and turn the far left burner control knob
counter clockwise to the "MAX" position(
5. Immediately strike a match or use a butane lighter, and position
through the lighting hole on the left side of the burner box. Shown
in figure A. Check to ensure that the burner is lit.
6. To light the other burners, press in and turn the nearest control
knob. The flame will track around the burner and light via the
carryover tubes. Allow the barbecue to preheat with the barbecue
lid closed for 10-15 minutes before cooking.
Lighting- Side Stove / Sear Stove (if applicable)
1. Open the side burner lid.
2. Check that the side burner valve is turned "OFF".
3. Turn the LP tank valve "ON" slowly (turn counter clockwise). Wait for pressure to stabilize for 5 seconds.
4. Push down and turn the side burner control valve to "MAX" (
5. Press the INSTASTART™ Ignition button. You should hear rapid clicks. Check to ensure that the burner
is lit. Repeat if neccessary.
The side burner lid is for storage only. Wait until cool before closing.
).
).
7
OFF
MIN
MAX
A
Model may not be exactly as shown.
).
MIN
MAX