Table of Contents
Advertisement
Tender Light:
Unplug wires
Unscrew light
from connectors
brackets
1. Remove the four (4) screws that
hold the chassis to the body and pull
the two components apart, being
careful to leave the wires attached.
2. Unplug the green wire from the
connector.
3. Unscrew the bracket that houses the
light bulb from inside the tender.
4. Gently pull the bulb to remove it and
Figure 8. Changing the Tender Light.
push the replacement into place.
5. Reassemble in reverse order, being
careful not to pinch any wires.
Firebox and Cab Interior Lights:
1. Remove the boiler from the engine (see Fig. 7 on pg. 12). To do this,
unscrew the leading truck bracket and move it aside to access the front body
mount screw. Remove the one front and two rear body mount screws and
carefully lift the boiler from the chassis, being careful to leave the wires
attached.
2. Unplug the black wires from their connector. You must change both the
firebox light and cab interior light at the same time.
3. Remove the firebox light bulb by pulling it down and out of its bracket.
You may find it easier to unscrew the bracket from the boiler before removing
the bulb. Replace the bulb by pushing it up and into the bracket. You may
need to use small pliers to do this.
4. Remove the cab interior light by pulling gently on the wire until the bulb
comes free of its housing. Push the replacement bulb into position.
5. Reassemble in reverse order, taking care not to pinch any wires.
16
Premier 4-4-2 Atlantic E-6 Steam Engine
Advertisement
Table of Contents
