Canceling The Program; End Of Program - Beko DCY 9502 GXB3 User Manual

Operating the product
When child-lock is activated:
If the position of program selection button is changed,
there will be no change at display symbols, both when
the machine is at run mode or stop mode.
5.13 Changing the program after
initializing
You can change the program after the machine
initializes the program and dry your laundry with a
different program.
For instance, for changing to Extra Dry from Ironing
Dryness, press Start / Hold button to stop the
program.
Select Extra Dry using Program Selection button.
Press Start/Hold button to initialize the program.
Adding or removing laundry in Hold mode
If you want to add or remove laundry after drying
program was initialized:
Press Start / Hold button to enter Hold mode. Drying
progress will be paused.
Open loading door at Hold mode, add or remove laundry
and than close the loading door.
Press Start/Hold button to initialize the program.
C
Adding laundry after drying program was
initialized may cause already dried laundry
inside the machine intermingle with wet
laundry and as a result laundry will be
damp after drying program is over.
C
During drying process, you can repeat
adding or removing laundry as much as
you want. But this action will interrupt the
drying process every time and causes
a longer drying period and increases
power consumption. Therefore, it is
recommended to add laundry before
program initializes.
C
If you change the position of program
selection button to select a new program
when the machine is in pause mode,
actual program will be terminated and
information about the new program will be
displayed.
WARNING: Do not touch inner surface of
drum when loading of unloading laundry.
Surface of drum will be hot.
Dryer / User Manual

5.14 Canceling the program

For any reason, if you want to cancel the actual program
and stop drying process, press and hold ON/OFF/Cancel
button for 3 seconds.
A
WARNING: Since inside of the machine
will be extreme hot, when you cancel the
program activate aeration program for
cooling down.

5.15 End of program

Fiber Filter Cleaning and Water Tank warning symbols
will be on when the program ends. You can open the
loading door and machine is ready for the next cycle.
To turn off the machine, press ON/OFF/Cancel button.
C
If Anti-Creasing function is activated
and laundry are not removed from the
machine, Anti-Creasing program will start
for a period of 2 hours (this period varies
depending on selection).
C
Clean the fiber filter after each cycle. (See
"Fiber filter and Inside surface of Loading
Door")
C
Empty water tank after each cycle. (See
"Emptying water tank")
23 / 28 EN