Table of Contents
Advertisement
Making calls
1
Lift the handset and dial the phone
number.
R To correct a digit, press MCN.
2
M
N
3
When you finish talking, press MeN or
place the handset on the charger.
Using the speakerphone
1
Dial the phone number and press MZN.
2
When you finish talking, press MeN.
Note:
R To switch back to the receiver, press MZN/
M
N.
Adjusting the receiver or speaker
volume
Press MDN or MCN repeatedly while talking.
Making a call using the redial list
The last 10 phone numbers dialled (each 24
digits max.) are stored in the redial list.
1
MEN (T)
2
MbN: Select the desired phone number.
3
M
N
Erasing a number in the redial list
1
MEN (T)
2
MbN: Select the desired phone number.
a M
N
3
MbN: "Yes" a MOKN a MeN
Pause (for PBX/long distance
service users)
A pause is sometimes required when making
calls using a PBX or long distance service.
When storing a calling card access number
and/or PIN in the phonebook, a pause is also
needed (page 21).
Helpline Tel. No.: U.K. 0330 3331112 Ireland 01 4475228
HNH100E_(en_en)_0421_ver.051.pdf
Example: If you need to dial the line access
number "0" when making outside calls with a
PBX:
1
0 a MDN (Pause)
2
Dial the phone number. a M
Note:
R A 3 second pause is inserted each time MDN
(Pause) is pressed.
Answering calls
1
Lift the handset and press M
when the unit rings.
2
When you finish talking, press MeN or
place the handset on the charger.
Any key answer: You can answer the call by
pressing any dial key.
Auto talk: You can answer calls simply by
lifting the handset (page 26).
Temporary handset ringer off: You can turn
the ringer off temporarily by pressing M
Adjusting the ringer volume
Press MDN or MCN repeatedly to select the
desired volume while ringing.
Caller ID features
When an outside call is being received, the
caller information is displayed.
Important:
R This unit is Caller ID compatible. To use
Caller ID features, you must subscribe to a
Caller ID service. Contact your phone
service provider for details.
R If the unit cannot receive caller information,
the following is displayed:
– "Out of Area": The caller dials from
an area which does not provide a Caller
ID service.
– "Private Caller": The caller
requests not to send caller information.
R If the unit is connected to a PBX system,
caller information may not be properly
received. Contact your PBX supplier.
15
Making/Answering Calls
N
N or MZN
2015/04/22
N.
15
19:08:46
Advertisement
Table of Contents
