Table of Contents
Advertisement
Installation
3.1 Appropriate installation location
• Place the product on a solid and level floor. Do not place it onto a carpet with high
pile or other similar surfaces.
• Do not place the product close to the edge if the floor contains steps. Do not also
place the product on a platform.
• Do not place the product on the power cable.
• Do not install the product in environments where the temperature falls below 0
ºC.(See. Warnings for Drying)
• Place the product at least 1,5 cm away from the edges of other furniture.
In the area where this product is installed, there must not be a lockable, sliding or
hinged door that will restrict the full opening of loading door.
Operate the product in a well ventilated and dust free environment.
3.2 Removing packaging reinforcement
Tilt the machine backwards to remove the packaging reinforcement. Remove the
packaging reinforcement attached to the ribbon.
DANGER!
Your
reinforcement as displayed in the figure.
Be careful not to get your hand caught under the
machine during this procedure.
User's Manual
product
is
heavy.
Remove
packaging
19 / EN
Advertisement
Table of Contents
