Beko WDX 8543130W User Manual page 65

Hide thumbs Also See for WDX 8543130W:
Table of Contents

Advertisement

Troubleshooting
• Draining hose is not at adequate height. >>>
described in the user manual.
No water can be seen in the machine during washing.
• The water level is not visible from outside of the washing machine. This is not a
failure.
Loading door cannot be opened.
• Loading door lock is activated because of the water level in the machine. >>>
Drain the water by running the Pump or Spin programme.
• Machine is heating up the water or it is at the spinning cycle. >>>
programme completes.
• Loading door lock is engaged. Loading door lock will be deactivated a couple of
minutes after the programme comes to an end. >>>
deactivation of the loading door lock.
Washing takes longer than specified in the user manual.(*)
• Water pressure is low. >>>
to prevent poor washing quality due to the decreased amount of water. Therefore, the
washing time extends.
• Voltage is low. >>>
supply voltage is low.
• Input temperature of water is low. >>>
in cold seasons. Also, washing time can be lengthened to avoid poor washing results.
• Number of rinses and/or amount of rinse water have increased. >>>
increases the amount of rinse water when good rinsing is needed and adds an extra
rinsing step if necessary.
• Excessive foam has occurred and automatic foam absorption system has been
activated due to too much detergent usage. >>>
detergent.
Programme time does not countdown. (On models with display) (*)
• Timer may stop during water intake. >>>
the machine takes in adequate amount of water. The machine will wait until there is
sufficient amount of water to avoid poor washing results due to lack of water. Timer
indicator will resume countdown after this.
• Timer may stop during heating step. >>>
the machine reaches the selected temperature.
• Timer may stop during spinning step. >>>
system might be activated due to the unbalanced distribution of the laundry in the drum.
Programme time does not countdown. (*)
• Laundry is unbalanced in the machine. >>>
system might be activated due to the unbalanced distribution of the laundry in the drum.
Machine does not switch to spinning step. (*)
User's Manual
Machine waits until taking in adequate amount of water
Washing time is prolonged to avoid poor washing results when the
Connect the water draining hose as
Wait for a couple of minutes for
Required time to heat up the water extends
Use recommended amount of
Timer indicator will not countdown until
Timer indicator will not countdown until
Automatic unbalanced load detection
Automatic unbalanced load detection
Wait until the
Machine
65 / EN

Advertisement

Table of Contents
loading

Table of Contents