Tecumseh tvt691 Operator's Manual page 7

B. Filling Oil Sump
If your engine has an oil fill cap go to step 1. If your engine
has an oil fill plug see "Oil Fill Cap Without Dipstick"
instructions on the next page.
1. Be sure engine is upright and level.
2. Unscrew oil fill cap from oil filler tube and wipe dipstick
clean. See Figure 7.
3. Screw oil fill cap back into oil filler tube. Tighten
securely.
4. Unscrew and remove oil fill cap from oil filler tube. Note
oil level. If oil reading on dipstick is below "ADD" mark,
slowly add oil to reach "FULL" level. See Figure 6.
5. Screw oil fill cap back into oil filler tube. Tighten
securely.
6. Wipe away any spilled oil.
C. Filling Fuel Tank
An adult should fuel this engine.
WARNING
!
NEVER allow children to refuel this
engine. Gasoline (fuel) vapors are highly flammable and
can explode. Fuel vapors can spread and be ignited by a
spark or flame many feet away from engine. To prevent
injury or death from fuel fires, follow these instructions:
1. Stop engine and allow it to cool before refueling.
2. Be sure engine is outdoors and in a well-ventilated
area.
3. Clean area around fuel fill cap and remove fuel fill cap.
4. Using an approved red GASOLINE container, add fuel
slowly, being careful to avoid spilling. DO NOT overfill
fuel tank. Leave space in the tank to allow fuel to
expand without overflowing.
5. Replace fuel fill cap securely and wipe up spilled fuel
before starting engine. If fuel is spilled DO NOT start
engine. Move machine away from area of spillage.
Avoid creating any source of ignition until fuel vapors
are gone.
181-1203-14 Four-Cycle Twin Cylinder Engine • Vertical Crankshaft • Air-Cooled
2 3
1 6
1. Oil Drain Plug
2. Oil Fill Cap and Dipstick
3. Air Intake Screen
4. Grounding Post
5. Spark Plug Cap
6. Spark Plug Wire
Figure 7. Engine with Oil Fill Dipstick
5 4
Page 5