Remove The Laundry; End Of Programme/Anti-Crease - Miele tmr640wp Operating Instructions Manual

End of programme/Anti-crease

At the end of the programme: Anti-
crease (if selected) or Finish will light
up. The Start/Stop button will no longer
be lit up.
To save energy, 10 minutes after the
end of the programme the Start/Stop
button will begin to flash slowly and the
display will go out.
The dryer will switch off automatically
15 minutes after the end of the anti-
crease phase (with programmes without
an anti-crease phase it will switch off
15 minutes after the end of the
programme).

Remove the laundry


Never open the door before the
drying process has finished.
 Pull the door open at the side with
the orange marker.
 Remove the laundry.
4. Remove the laundry
Check that all items have been
removed from the drum.
If items are left in the dryer, they
could be damaged by overdrying
when the dryer is next used.
If the dryer is switched on at the mains
and the door is opened, the drum
lighting will come on. It will go out a few
minutes later to save energy.
 If the dryer is still switched on, switch
it off with the  button.
A buzzer will sound.
 Remove the fluff from the 2 fluff filters
in the door opening: see "Cleaning
and care - Fluff filters".
 Shut the door with a gentle swing.
 Empty the condensed water
container.
Tip: The condensed water can be used
for the Steam smoothing programme.
See "Cleaning and care - Preparing the
condensed water container for Steam
smoothing".
We recommend that you drain the
condensed water externally through the
drain hose when drying a full load using
the Cottons and Cottons 
programmes. This will avoid having to
empty the condensed water container
during the programme.
31